Compute Module • Power led blinking after end provisioning

Hi,
I'm working with CM4 and and using the official provisioning procedure for my project.

I noticed that the power led (D1 on the IO board) flashes at the end of the procedure. During the rest of the procedure it is solid red.
What I then do is remove the power from the board and reconnect it, after which the led remains solid (as I expected it to do in fact) and the system works correctly.

I have verified this with 25 CM4 and several IO boards.

So my question is:
is the flashing automatically controlled to indicate that a HW reboot is needed?

Thanks in advance

Statistics: Posted by marco2123 — Thu Oct 24, 2024 8:43 am — Replies 0 — Views 12

---