I have a CM4 interfaced with a regular picam and an Analog Devices ToF module, the pica uses regular csi connector while the TOF module uses FH26W-25S-0.3SHW(60) https://www.digikey.com/en/products/det ... 60/5132498
When mounted there is a strain in the cable as pictured below![Image]()
and a streaking pattern is observed from feeds on the both modules.
![Image]()
It however disappears, either if the cables are left straight flat on the table, glued down, both solutions do not actually solve the issue in long term.
Any Pointers?
![Image]()
Image depicting pressure on the cable/connector that resolves the issue temporarily
When mounted there is a strain in the cable as pictured below
and a streaking pattern is observed from feeds on the both modules.
It however disappears, either if the cables are left straight flat on the table, glued down, both solutions do not actually solve the issue in long term.
Any Pointers?
Image depicting pressure on the cable/connector that resolves the issue temporarily
Statistics: Posted by akurhade — Mon Jan 22, 2024 2:52 pm — Replies 3 — Views 118