Dear all,
I did not use Raspberrys for a long time, I hope this is the right place for my problem / my new "first post", if not please tell me where better. My setup:
Laptop-OS: Ubuntu 22.04, Raspberry Pi Imager v1.8.5
Hardware: Raspberry zero W with 5MP Camera connected, mobile phone charger, 32GB SD-Card
Software: Used the Imager with settings: RaspberryPi Zero, RaspberryPi OS (other) / Raspberry Pi OS Lite (32bit)
Set my WLan data, hostname, user pass, enabled SSH.
Then powering the device, logging in by ssh - success.
So far so good![:-)]( "Smile")
Then I did "sudo apt-get update" and finally "sudo apt-get install motion" - that gives this output:
https://pastebin.com/8w6g6PNN
I am confused, because it tells the user already exists, and that there are permission problems - but I did not yet configure anything in the system after the imager - so what did I miss?
OR can somebody with a similar setup just try what I did and compare?
I did not use Raspberrys for a long time, I hope this is the right place for my problem / my new "first post", if not please tell me where better. My setup:
Laptop-OS: Ubuntu 22.04, Raspberry Pi Imager v1.8.5
Hardware: Raspberry zero W with 5MP Camera connected, mobile phone charger, 32GB SD-Card
Software: Used the Imager with settings: RaspberryPi Zero, RaspberryPi OS (other) / Raspberry Pi OS Lite (32bit)
Set my WLan data, hostname, user pass, enabled SSH.
Then powering the device, logging in by ssh - success.
So far so good
Then I did "sudo apt-get update" and finally "sudo apt-get install motion" - that gives this output:
https://pastebin.com/8w6g6PNN
I am confused, because it tells the user already exists, and that there are permission problems - but I did not yet configure anything in the system after the imager - so what did I miss?
OR can somebody with a similar setup just try what I did and compare?
Statistics: Posted by raspidiot — Sun Feb 25, 2024 8:58 pm — Replies 3 — Views 63