Hello!
I am trying to interface an Ir receiverwith a raspberry pi zero. I would like to drive a 5V relè to turn on my personal computer.
I correctly connected supply voltag, ground and out pins on the board and followed this procedure (https://www.digikey.com/en/maker/tutori ... spberry-pi) to start decoding signals from my tv remote controller.
Unfortunately lirc installation doesn't include important configuration files like /etc/lirc/lirc_options.conf
If I try to stop the lirc daemon it stops without any problem but if I start it again I get errors.
Any idea on what is missing?
Should I reinstall raspbian from zero?
I am trying to interface an Ir receiverwith a raspberry pi zero. I would like to drive a 5V relè to turn on my personal computer.
I correctly connected supply voltag, ground and out pins on the board and followed this procedure (https://www.digikey.com/en/maker/tutori ... spberry-pi) to start decoding signals from my tv remote controller.
Unfortunately lirc installation doesn't include important configuration files like /etc/lirc/lirc_options.conf
If I try to stop the lirc daemon it stops without any problem but if I start it again I get errors.
Any idea on what is missing?
Should I reinstall raspbian from zero?
Statistics: Posted by Lorenz23 — Thu Oct 03, 2024 8:07 pm — Replies 1 — Views 30