Raspberry Pi Connect • Issue setting up Connect

Hello everyone,

I am trying to set up Raspberry Connect on my RPi 5 (Bookworm).
I am following the procedure as detailed on the following website: https://www.raspberrypi.com/documentati ... nnect.html .

At the step: $ sudo apt install rpi-connect
I get the following error:

Reading package lists... Done
Building dependency tree... Done
Reading state information... Done
Some packages could not be installed. This may mean that you have
requested an impossible situation or if you are using the unstable
distribution that some required packages have not yet been created
or been moved out of Incoming.
The following information may help to resolve the situation:

The following packages have unmet dependencies:
wayvnc:arm64 : Depends: libaml0:arm64 (>= 0.3.0) but it is not going to be installed
Depends: libc6:arm64 (>= 2.34) but it is not going to be installed
Depends: libdrm2:arm64 (>= 2.4.75) but it is not installable
Depends: libgbm1:arm64 (>= 17.1.0~rc2) but it is not going to be installed
Depends: libjansson4:arm64 (>= 2.14) but it is not installable
Depends: libneatvnc0:arm64 (>= 0.9.0+dfsg) but it is not going to be installed
Depends: libpam0g:arm64 (>= 0.99.7.1) but it is not going to be installed
Depends: libpixman-1-0:arm64 (>= 0.25.2) but it is not going to be installed
Depends: libwayland-client0:arm64 (>= 1.20.0) but it is not going to be installed
Depends: libxkbcommon0:arm64 (>= 1.0.0) but it is not installable
Depends: python3:arm64 but it is not installable
Depends: raspi-config:arm64 but it is not installable
E: Unable to correct problems, you have held broken packages.


I am quite a novice here, so I count on your help and advice.
Thank you in advance

Statistics: Posted by theoo — Thu May 16, 2024 2:55 am — Replies 0 — Views 11

---